Taiwan Class A Compliance Statement; Electronic Emission Notices; Federal Communications Commission (Fcc) Statement - IBM BladeCenter Installation Manual

Taiwan Class A compliance statement

Electronic emission notices

When you attach a monitor to the equipment, you must use the designated
monitor cable and any interference suppression devices that are supplied with
the monitor.

Federal Communications Commission (FCC) statement

Note: This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user
will be required to correct the interference at his own expense.
Properly shielded and grounded cables and connectors must be used in order
to meet FCC emission limits. IBM is not responsible for any radio or television
interference caused by using other than recommended cables and connectors or
by unauthorized changes or modifications to this equipment. Unauthorized
changes or modifications could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
38
Server Connectivity Module: Installation Guide