Page 1
Motorized vehicle MicroLite MDSS GmbH Schiffgraben 41 30175 Hannover, Germany Distributor: User Manual You must read this manual before using your MicroLite P/N: 9038500 Rev. 01a/20...
MicroLite. recommended that someone accompanies you during practice. ● The MicroLite was designed for hard and flat surfaces. It should Always contact your dealer, distributor, service agent or not be used on steep slopes or loose surfaces manufacturer about problems or conditions you do not understand.
Page 4
D. MOTOR VEHICLE SAFETY A. ENVIRONMENTAL CONDITIONS WARNING: The scooter is not i. Never sit on this scooter while in a moving vehicle. designed for use in a heavy rain storm, or in snowy or icy ii. Always move to an approved vehicle seat. conditions.
ELECTROMAGNETIC INTERFERENCE H. DRIVING IN REVERSE WARNING: Use extra care when you drive your scooter in reverse. You may lose control or fall if one I t i s v e r y i m p o r t a n t t h a t y o u r e a d t h i s i n f o r m a t i o n r e g a r d i n g t h e p o s s i b l e e f f e c t s o f of the rear wheels hits an object.
Page 6
● Important Information 1) 20 Volts per meter (V/m) is a generally achievable and useful immunity level against interference from radio wave sources (as of May 1994) (the higher the level, the greater the operate hand-held personal protection); 2) This product has an immunity level of following: communication devices such as citizens band (CB) radios, or turn ON Guidance and manufacturer’s declaration-electromagnetic immunity personal communication devices and cellular phones while the...
ASSEMBLE THE SEAT FOLDABLE SEAT FRAME To open the seat frame Assemble the seat frame in the manner illustrated. Pull out the knob “P” in the direction of the arrow and lift the seat tube “O” up as illustrated. The ARROW must point to the FRONT When assembling the seat to the frame Push the support lever in the direction of the arrow until it clicks...
TO OPEN THE MICROLITE ● Use one hand to hold the tiller handle and use the other hand to push the lock pin lever (A) per the illustration and lift the handle. Continue lifting the tiller until you hear the “click”, the locking into ●...
Position “H” provides the greatest stability. Return the sliding tube to position “J” for transportation or disassembly. The partition board (PB) on your MicroLite is not designed to be load bearing, have your feet always stay on the footrest (M) per indicated above.
FLAT PACK KIT: (optional) SEAT POST CLAMP - OPTIONAL To store folded seat onto scooter Assemble the guide pin for each seat post as per illustration Make sure that stop pin “J” is touching horizontal plate “H”. Before tightening screws “D”, put the two guide pins into corresponding ●...
● Z : Battery green level gauge Note: I,W,X,L,Y These features not fitted to the MicroLite. Do not place your fingers on the speed lever before you turn the key switch “On”. Do not operate speed selection switch “J” when scooter is moving.
MicroLite can be moved manually. Scooter being recharged with the Green light flashes slowly key switch turn on. Do not ride your MicroLite when magnetic brake lever is in the Low voltage of batteries detected Yellow & Red light ON by controller “FREE WHEEL”...
● Do not store your scooter outside without adequate protection. ● Keep the shipping carton in dry place after unpacking your MicroLite in case it needs to be shipped for service. ● This appliance is not intended for persons (including children) with...
FOLD THE MICROLITE ● Remove battery module from scooter ● Use one hand to hold the handle, and use the other hand to pull the lock pin knob (G) and turn it anticlockwise. Then fold the handle down until you hear the “click”...
CHARGE BATTERY Or remove the battery from scooter, and charge battery individual. ● When you get your new battery put it on charge for 24 hours. wing the charger’s cover away (T) as arrow direction. ● S ● When recharging your battery, always charge it until the light on Plug the charger power cord (Round plug) (S) into the socket ●...
BATTERY CHARGER Estimated travel distance with 80kg load For your safety and proper use of battery module, we strongly This larger recommend that you read this manual completely before use. 24V 11.6ah 10 -13 km battery is ● For indoor use only, do not expose to rain. Lithium Battery (6.2 - 8 miles) ●...
30 degrees Celsius. Insure that to have terminal cover is closed. 2. Use the battery module: 1. The battery module is designed for SupaScoota mobility scooters Recharge it before the next use. only. Do not use battery module on any other equipment.
BATTERY SAFETY INSTRUCTION During use, charge, or storage 1. Do not put battery module in your pockets or bags together with 1. Do not disassemble or modify battery module. The battery metal objects such as golf clubs, necklaces, hairpins, coins, or module contains safety and protection devices.
Specifications MicroLite Warranty Number of Wheels Your MicroLite is fully guaranteed against faults arising due to Front Wheel Size 175mm (7”) defects in manufacture or materials as follows Rear Wheel Size 175mm (7”) 45 mm (1.7”) Frame: 2 years. Ground Clearance (tiller) Length 930 mm (36.5”)
Page 20
This warranty record must be kept by the purchaser and a copy supplied with any claim I / we acknowledge that the MicroLite has been delivered in good order and operating condition and that I / we have been instructed in the care and maintenance, safe operation and proper use of unit.
Need help?
Do you have a question about the MicroLite and is the answer not in the manual?
Questions and answers