Advertisement
www.freeservicemanuals.info
Controls
DN
Press
the control
TA mode
VOL
UP
TA mode: Rotate the
control
traffic program identification code received in the specified time, no TA/TP will display and either TA ALARM or TA SE EK will
be activated.
TA ALARM mode : Alarm is turned on.
DN
MASK mode:
Rotate the
control
VOL
to choose MASK
DPI or MASK ALL
UP
mode.
PUSH SE L
RETUNE-S
RETUNE mode:
RETUNE-S:
Rotate the control to
RETUNE-L:
choose RETUNE-S
Remark: RETUNE
or RETUNE-L
DN
DSP mode: Rotate the
VOL
LOUD mode: Rotate the control to choose loudness on or off.
UP
BEEP ON/OFF mode: Rotate the control to choose button beep sound on or off.
PUSH SEL
SEEK 1/2 mode: Rotate the control to choose radio seek mode 1 or 2 .
SEEK 1: searching station will stop when next station is received.
SEEK 2: searching station will stop when
LOCAL/DX mode: Rotate the control to choose tuner sensitivity local or distant.
STEREO/MONO mode: Rotate the control to choose FM stereo or mono.
for more than 2 seconds to enter the menu mode, then each press changes the mode as follows:
MASK mode
RETUNE mode
VOL mode
LOCAL/ DX mode
(only in tuner mode)
to choose TA ALARM or TA SEEK mode. When the Traffic Announcement (TA) is turned on, if there is
In some cases, the AF function may be influenced by some interference, examples are signals with
strong field but without the RDS data.For this reason, the unit has two options to avoid the above
interference.
MASK DPI mode :
Only AF which has different program identification is masked.
MASK ALL mode :
The AF which has different program identification and NO RDS
signal with high field strength is masked.
or
RETUNE-L
is time length selection of TA SEEK retune interval.
short, TA SEEK retune interval is 45 seconds.
long, TA SEEK retune interval is 180 seconds.
mode functions for TA during TA SEEK mode only.
control
to choose DSP sound effect:
or
button is released and next station is received.
VOL LAST / ADJUST MODE
Rotate control to choose
memory to retain the volume level last used before you
switch off the unit.
Rotate control to choose VOL ADJ:
then rotate the control to set to the volume level you want as
your default volume level setting for whenever you switch on the unit.
1-8
DSP mode
LOUD ON / OFF
STEREO / MONO mode
(only in FM mode)
TA SEEK mode: TA automatically SEEK is activated.
P
OP
ROCK
VOL LAST :
this enables the unit's
BEEP ON / OFF
SEEK1/2 mode
(only in tuner mode)
no
CLASS
FLAT
DSP OFF
Advertisement
