Sony Trinitron PGM-200R1A Operating Instructions Manual page 12

Operating a Specific Monitor With the Remote
Commander
Using the supplied Remote Commander, you can
operate a specific monitor without affecting other
monitors that are installed together.
1
Press ID MODE ON on the Remote Commander.
Monitor index numbers appear in white characters
on all the monitors. (Every monitor is allocated an
individual preset index number from 1 to 255. See
"To change the index number" in the column to
the right on this page to change the index number.)
ON
SET
OFF
ID MODE
2
Input the index number of the monitor you want to
operate using 0 – 9 buttons on the Remote
Commander.
The input number appears right next to each
monitor's own index number.
1 2 3
4 5 6
7 8 9
10/0
3
Press ID MODE SET.
The character on the selected monitor changes to
cyan while others change to red.
ON
SET
OFF
ID MODE
Now you can operate only a specified monitor.
(All operations are available in ID mode except
POWER ON/OFF.)
12
12
(EN)
4
After necessary adjustment, press ID MODE OFF.
The monitor returns to the normal mode.
ON
SET
OFF
ID MODE
To change the index number
You can change the index number if necessary.
When you change the number, use the buttons on the
monitor.
1
Display MENU 3 screen by pressing the MENU
button.
2
Select INDEX NO. with the SELECT +/– buttons
and press the ENTER button.