LaserLiner SmartCross-Laser Manual page 5

Read the operating instructions and the enclosed brochure „Guarantee
!
and additional notices" completely. Follow the instructions they
contain. This document must be kept in a safe place and if the laser
device is passed on, this document must be passed on with it.
The automatic cross-line laser for aligning tiles, wall studding, windows,
doors etc.
General safety instructions
– The device must only be used in accordance with its intended purpose
and within the scope of the specifications.
Do not stare into the beam!
– Attention: Do not look into the direct or reflected beam.
– Do not point the laser beam towards persons.
– If a person's eyes are exposed to class 2 laser radiation, they should shut their
eyes and immediately move away from the beam.
– Under no circumstances should optical instruments (magnifying glass,
microscope, binoculars) be used to look at the laser beam or reflections.
– Do not use the laser at eye level (1.40 ... 1.90 m)
– Reflective, specular or shiny surfaces must be covered whilst laser devices are in
operation.
– In public areas shield off the laser beam with barriers and partitions wherever
possible and identify the laser area with warning signs.
– Tampering with (making changes to) the laser device is not permitted.
– This device is not a toy - keep out of the reach of children.
!
Always turn off all lasers and latch the pendulum in place before
transporting, ON/OFF switch in its „OFF" position!
Inserting batteries
1
Open the battery compartment
and insert batteries (2 x type AA)
according to the symbols. Be sure
to pay attention to polarity.
1
7
2 Horizontal and vertical levelling
Release the transport restraint,
set the ON/OFF switch to
„ON". The laser cross will
appear. The laser lines can
be switched individually
with the selection button.
Laser radiation!
Class 2 laser
< 1 mW · 650 nm
EN 60825-1:2014
1
2
2
3
3
4
4
5
5
6
7
6
LASER
SmartCross-Laser
–
+
–
Laser line selection button /
Hand receiver mode
LED levelling
red: levelling off
green: levelling on
Battery compartment (backside)
ON / OFF switch,
transport retainer
Laser output windows
1/4" tripod threads (bottom)
LED hand receiver mode
LASER LASER LASER
05
EN