Table of Contents
Advertisement
Fitting the WSF flat roof frame
▶ Screw flat profiles 1650/1570 mm together to form a wind cross.
x = 1650
x = 1570
Fig. 25 Screwing flat profiles together to form a wind cross
▶ Screw the top of the wind cross along with the storage tank support
(profile 670 mm) to the profile 1380 mm [1]. The screw head points
to where the storage tank will be installed later ( arrow).
▶ Mount the bottom of the wind cross to profile 1380 mm [2].
1
2
B
Fig. 26 Installing the wind cross
1
1
A
2
Fig. 27 Fitting wind cross for the second collector (TSS300)
14
0010014823-01
2
A
0010014824-01
2
B
A
0010014825-01
6.3
Installing the profile rails
▶ Align the angle profiles 2215 mm at the bottom so they are parallel to
each other.
▶ Place the profile rails in the centre and screw them together.
▶ Tighten all screw connections of the angle, flat and U profiles
(corresponds to approx. 15 Nm).
1
Fig. 28 Installing the upper and lower profile rails
The triangles above the elongated holes mark the position of the anti-slip
protectors.
▶ Push the anti-slip protector down over the profile rail and let it click
into the slot.
Fig. 29 Installing anti-slip brackets on the lower profile rails
[1]
Lower profile rail for two collectors
[2]
Lower profile rail for one collector
0010014826-01
click!
0010014827-01
TSS – 6720887696 (2018/05)
1
2
Hide quick links:
Advertisement
Table of Contents
