Fitting Upper Clamps; Fitting Base Bracket And Lower Clamps - Bosch TSS Series Installation And Maintenance Instructions Manual

1. Slide up angle profiles.
2. Screw angle profiles to the assembly stand.
2.
1.
0010016140-01
Fig. 37 Fastening connected angle profiles to the assembly stand
7.3

Fitting upper clamps

Only slightly tighten the screw connections, so that the collector can still
be installed.
▶ When there is one collector, screw clamps directly onto the assembly
stand using an oval head screw ( arrow).
Fig. 38 MTSS1: Screw clamps directly onto the assembly stand
TSS – 6720887696 (2018/05)
▶ When there are two collectors, fit clamps to the angle profile using an
oval head screw ( arrow).
0010016141-01
Fig. 39 MTSS2: Screwing clamps onto angle profiles
7.4

Fitting base bracket and lower clamps

▶ Fit the base bracket so that
– the collector sits at the bottom of the base bracket profile [1] and
– the clamp grips the side of the collector edge [2].
▶ Tighten all screw connections (corresponds to approx. 15 Nm).
2 x
0010016152-01
Fig. 40 Fitting the base bracket
Installing the MTSS flat roof frame
4 x
2
1
0010016142-02
17