Table of Contents
Advertisement
3
Installing the Rinse Tank
Parts needed for this procedure:
2
Rinse-tank strap
2
Bolt
4
Washer
2
Locknut
1
Carriage bolt
Preparing the Tank
1. Loosen the bolts securing the valve mounting rail to
the frame
(Figure
6).
1
2
1. Mounting rail
2. Move the mounting rail rearward.
Note: This is a small adjustment that allows space for
installing the rinse tank.
3. Tighten the bolts to secure the mounting rail in this
position on the frame.
4. Torque the bolts to 40 N∙m (30 ft-lb).
5. Disconnect the supply hose at the rear and top of the
main tank
(Figure
7).
G014231
Figure 6
2. Bolt
1
1. Locknut
2. Bolt
3. Washer
4. Locknut
6. Remove the retaining fork securing the fitting and
remove the hose; retain all parts.
7. Remove the fasteners securing the rear tank straps at
the top of the tank; retain all parts.
8. Remove the inboard locknut securing the wire tank lid
stop to the left, rear strap; retain locknut.
Installing the Hardware for the
Rinse-Tank Straps
1. Install a carriage bolt to the inboard hole on the right
rear tank strap
(Figure
The carriage bolt on the rear left tank strap should pass
through the open loop of the wire tank lid stop.
G014286
1
1. Carriage bolt
2. Right-rear tank strap
2. Install the tank strap fasteners removed previously to
secure the straps to the tank.
Make sure that the strap is secure to the tank. Do not
overtighten.
5
2
3
6
7
G014232
Figure 7
5. Right-rear tank strap
6. Retaining fork
7. Supply hose
8).
2
3
Figure 8
3. Inboard hole
4
5
Advertisement
Table of Contents
