Fine Tuning - Bogen CAM8 Installation And Use Manual

Fine Tuning

Low Cut Switch
To remove excessive bass from an individual channel, press the Low Cut Switch (1) for that
channel.
+
-
M.A
BUS
This feature helps eliminate low frequency noise (signals of 150 Hz and below, such as back-
ground rumble from ventilation systems, etc.) and is used primarily with mic-level input. It is
particularly effective when handheld mics are used.
Phantom Power
If a condenser microphone(s) is not independently powered, press Phantom Power Switch
(2) to the "on" position.
The phantom power switch will power condenser (capacitor) mics through the mic cable.
Depressing the button simultaneously applies phantom power to all channels set to mic-level.
Page 16 of 32
+
-
Low M.A
1
Cut BUS
1