Table of Contents
Advertisement
Specifications
Cutting
Capacity:
12"Rectangle
Blade
speeds:
41-49-69-120MPM60Hz
Blade size: 3/4"×0.032×93"
Unpacking and clean-up
1. Finish uncrating the saw. Inspect it for
shipping damage. If any damage has
occurred, contact your distributor.
2. Unbolt the saw from the skid and place it
on a level surface.
3. Clean
rust
protected
kerosene, diesel oil, or a mold solvent. Do
not use cellulose-based solvents such as
paint thinner or lacquer thinner. These
will damage painted surfaces.
Assembly
1. Place blocking under the ends of the saw
base to allow wheel installation. Caution:
Make
sure
saw
temporarily supported.
2. Slide wheel axles through holes in base.
3. Slide wheels onto axles and fasten with
pins. Bend pins to hold in place.
4. Slide material stop bar (1, Fig.2) into base,
then take out nut and washer to tighten the
bar (1). Slide material stop (2) onto bar
and tighten bolt (3).
5. Slide cylinder bar (1,Fig.3) into base and
tighten. Slide cylinder (3) onto bar and
tighten nut (4). Slide the screw (2) into the
cylinder and tighten.
6. Remove transportation strap and keep for
later use should the saw be moved any
distance.
Coolant Tank Preparation
★ WARNING: Disconnect bandsaw from
the power source before making any
7" ×
7"Round
34-41-59-98MPM50Hz
surfaces
with
is
steady
while
repairs or adjustments! Failure to
comply may cause serious injury!
★
Use of a water-soluble coolant will increase
cutting efficiency and prolong blade life. Do
not use black cutting oil as a substitute.
Change
cutting
oil
manufacturers instructions as to its use and
precautions.
1. Disconnect machine from the power
often
and
follow
Advertisement
Table of Contents
