Table of Contents
Advertisement
16. Make all adjustments with the power off. Before any maintenance the power plug has to be
removed form the supply socket.
17. Disconnect machine from power source when making repairs.
Shut off power and clean the blade saw and work area before leaving the machine. Clear away
the waste residue so as to avoid accidental injury after working.
18. This machine is only used for horizontal metal cutting, not vertical woodworking cutting.
About the safety of optional accessories
There are two optional safety accessories. Please read in detail from this clause about the safety
use of these devices as following.
1. Optional positive mode interlock for pulley cover. If the cutting speed need to be changed
very often, you must choose this option.
2. Optional handle operated power disconnection device. If your machine is equipped with this
option, please disconnect power through this device for some situation. Otherwise, disconnect
power according to the instruction in the clause of operation.
Environment Requirements for Installation.
1. Be sure to provide sufficient light for operation according to the codes or regulations
published for local area. If your do not get the information about lighting, a light intensity of
300 Lux is the least value to be supplied.
2. The place where machine install must be flat and big enough for the operation.
Noise Level
1. The noise level of this machine is about 75 db (A) during operation.
2. While taking provisions for the risk of noise, the noise level of working environment should
be taken into consideration also.
Handling & Transportation of Machine
1. The total weight of this machine must be ensured before handling.
2. This machine can not be handled without help of lifting tools.
Transportation Methods
1. Always keep balance of the machine in transportation. Watch the gravity!
2. Drive folklift slowly and carefully.
Advertisement
Table of Contents
