Table of Contents
Advertisement
Product installation
3.
Install the X bracket
First put the X bracket on the installation frame at the middle of the solar power supply
system, then clip the 8 screws into the X bracket slot from the installation frame, last, use the
bracket hasp, M6 spring washer, M6 cap nut to fasten the bracket. (See
Picture 3
4. Install the bird spike
Using the self-tapping screw in the accessory to fasten the bird spike on the top frame of the
solar power system. (See
Picture
4)
Self-tapping
screw
Picture 4
Picture
3)
Bracket hasp
M6 spring washer
M6 cap nut
9
.
5
Install the solar power system
Connect the solar power system with the extended cables in the light pole and lock the
connectors in turns. Embed the light pole into the X bracket and use the dedicated tools to
fasten 6 M8*16mm and 2 M8*25mm screws. (If you use the electric wrench, torsion should be
set to 14N·m)(See Picture 5)
.
LED Street light installation
6
Connect the cantilever part to the extended cables of the LED street light and lock the connectors
in turns; Embed the LED street light bracket into the cantilever and fasten it by 6 M8*16 screw,
make sure the LED street light has installed stably on the light pole then the installation is
finished. (If you use the electric wrench, torsion should be set to 14N·m) (See Picture 5).
M8*16 screw
M8*25 screw
Picture 5
10
Advertisement
Table of Contents
