Page 1
Phone: 909.476.0900 Fax: 909.466.0130 Email: sales@leadsun-us.com S O L A R S T R E E T L I G H T LEADSUN Australia PTY LTD USER MANUAL Address: 42 Greens Road, Dandenong South, Victoria 3175 Phone: +61 1300 281 005 Fax: +61 3 8610 0393 Email: jeoffc@leadsun.com.au...
Page 2
Cautions Transportation and storage Please read the below cautions carefully before using the ULTRON series solar The product contains high capacity lithium-ion battery components, please follow the street light to avoid physical injury and product failure caused by improper use.
Page 3
Part Description The Part list is the whole product series functions instruction. The user can look up the corresponding function according to the purchased product. Name Brief Function Solar module To absorb solar energy and convert into electricity PIR sensor Motion detection LED module Illumination...
Page 4
Operation instruction Part List Check if all the components are complete before installation, the components and quantity of each set as follows: Daytime: while connect the LED street light to solar engine, it lights 20 seconds and then Off. It means the AE5 has been activated automatically.
Page 5
Before Installation 1. Installation Direction of Solar Panel 3.How to place the Gateway ? Each Gateway covers a range from 800m to 3000m, depends if there are barriers to block signal Please choose the appropriate model depending on the sunlight intensity of the place and transmission.
Page 6
Product installation Install the X bracket 3. Drill a Dia. 10mm through-hole that should be 90mm from top of pole. ( Picture First put the X bracket on the installation frame at the middle of the AE5 solar street light, then clip the 8 screws into the X bracket slot from the installation frame, last, use the bracket hasp, 4.
Page 7
Please use LEDSUN EDGE APP to remotely control and configure the street light, visit www.leadsunglobal.com and follow the steps to Download the LEADSUN EDGE. A. For APPLE users please go to the APP STORE and install the APP 'LEADSUN 2G/4G Antenna 2G/4G Antenna EDGE' .
Page 8
Troubleshooting Symptoms Troubleshooting steps Process Check that the lamp can be manually Refer to “Activation and Installation” section activated. on this user guide and run activation tests. Check if the solar panel is blocked Clear obstructions or change installation from the sunlight by houses, trees and location.
Need help?
Do you have a question about the ULTRON Series and is the answer not in the manual?
Questions and answers