Summary of Contents for Cervis SmaRT EBU-xH24XF Series
Page 1
™ EBU-xH24XF Base Unit User Manual U109.0.0 2018 Cervis, Inc.
Page 2
SmaRT EBU-xH24XF Base Unit This document is the property of Cervis, Inc. and cannot be copied, modified, e-mailed, or reproduced without the express prior written consent of Cervis, Inc. Cervis, Inc. reserves the right to change this manual or edit, delete, or modify any information without prior notification.
User Manual Table of Contents List of Figures ..........................i List of Tables ..........................i Cervis Inc. Safety Precautions ....................ii 1.0 SmaRT EBU-xH24XF Base Unit Introduction ..............1 2.0 Features ..........................1 3.0 EBU-xH24XF LEDs ....................... 2 4.0 EBU-xH24XF Mounting ......................3 5.0 EBU-xH24XF Wiring ......................
SmaRT EBU-xH24XF Base Unit Cervis Inc. Safety Precautions Read and follow all instructions. Failure to abide by Safety Precautions may result in equipment failure, loss of authority to operate the equipment, and personal injury. Use and maintain proper wiring. Follow equipment manufacturer instructions.
User Manual 1.0 SmaRT EBU-xH24XF Base Unit Introduction The versatile EBU-xH24XF base units feature an H-Bridge, sixteen FET (field effect transistor) high-side switching outputs or switch-to-ground digital inputs, two Form C relays, and CAN Bus control capability. Using Direct Sequence Spread Spectrum (DSSS) wireless technology at 900MHz or 2.4GHz, the base unit provides a robust link with a SmaRT handheld remote in congested radio environments.
SmaRT EBU-xH24XF Base Unit 3.0 EBU-xH24XF LEDs The EBU-xH24XF has five status/system LEDs that indicate the current state of the active base unit and can be used for troubleshooting when necessary. These LEDs are defined in Table 1. Table 1. EBU-xH24XF LEDs Name Color Indication...
6 inch flying leads for wiring to appropriate outputs. Table 3 defines the cable plug pins, the pin type, and the match to the numbered flying lead. For instance: Pin 1 of Connector A is described as 1:M1: 1, where 1(connector pin): M1 (the defined 2018 Cervis, Inc.
SmaRT EBU-xH24XF Base Unit 5.2 Individual Wiring Harness Models HN-1016 to HN-1019 Individual wiring harness models HN-1016, HN-1017, HN-1018, and HN-1019 are illustrated and defined in the following four tables and figures. Each have pins (1-12) that directly relate to the individually numbered leads (1-12) of the each cable, though the output assignments of each cable are unique to the specific cable as shown in the following four tables.
SmaRT EBU-xH24XF Base Unit 6.0 SmaRT Handheld & Base Unit Remote Association A SmaRT remote control system must have communications between the SmaRT handheld control unit and the EBU-xH24XF base unit is set up at the factory using an Associate process prior to shipping the system.
Plug B (Black) 5: RS232RX 6: M21 7: M22 8: M23 Pins 1-12 9: M24 10: +VIN 11: GND 12: GND Note: EBU-xH24XF-CAN units are internally terminated at 1.2k .Termination can be removed at the factory. 2018 Cervis, Inc.
EXT-10-200 3 ft. antenna cable (J5-07) and external antenna (BB3-06) EXT-3-900 3 ft. antenna cable (J5-07) and external antenna (BB3-07) EXT-3-200 Note: Only the antenna recommended by Cervis, Inc. is to be used with the SmaRT base unit. U109.0.0...
Individually numbered 6 inch flying leads One 12-pin connector; 12 wire; 90 inch total length HN-1018 BLACK Individually numbered 6 inch flying leads One 12-pin connector; 12 wire; 90 inch total length HN-1019 BROWN Individually numbered 6 inch flying leads 2018 Cervis, Inc.
Page 16
SmaRT EBU-xH24XF Base Unit History Table Date Action 1/10/18 REVIEW 1/15/18 REVIEW (MAM, AMD edits) 1/15/18 Original Release www.cervisinc.com Visit our Web site at: 2018 Cervis, Inc. All rights reserved. Content is subject to change without notice. U109.0.0...