Assembling The Model; Installing The Landing Gear; Establishing The Electrical Connections; Attaching The Wing - Reely TWINS Operating Instructions Manual

9. Assembling the model

A1 A2 A3 A4 A5
This section explains how to assemble the model. The assembled model is shown in fig.
Follow the steps in the specified order.

9.1 Installing the landing gear

A1
9.1.1 Front
1. Insert the landing gear from underneath through the slot in the fuselage as far as it will go. The landing gear must
be tilted to the rear.
2. To secure the landing gear, run the power supply cable under the landing gear frame and through the opening in
the fuselage to the outside.
9.1.2 Rear
Guide the wheel through the slot in the fuselage as far as it will go. The landing gear must be tilted to the rear.

9.2 Establishing the electrical connections

A2
Do not use force when connecting the cables. Each connector can only be inserted in one orienta-
tion into the corresponding socket.
1. Connect the left motor power cable
2. Connect the right motor power cable

9.3 Attaching the wing

A3
The wing must be attached with double-sided adhesive tape.
1. Place the wing onto the fuselage to determine its position before securing it in place.
2. Attach double-sided tape to the wing mounting surface on the fuselage:
- If adhesive strips are already attached to the lower fuselage section, remove the protective film from each side.
- If the adhesive strips are in the packaging, attach them to both sides and remove the protective film from each
side.
3. Place the wing on the fuselage, ensuring that it is in the central position. Make sure that the wing is securely in
place in the corresponding holes on the fuselage.
38
to the upper socket on the board.
A2-L
to the lower socket on the board.
A2-R
.
A5