Assembling The Model; A) Gluing On The Wing Halves; B) Gluing The Wings To The Fuselage - Reely Sky Sedan Operating Instructions Manual



6. Assembling the Model

Before assembling the model, please read each individual section carefully. The construction stages are
illustrated for better understanding.
Please note that the numbers in the text always refer to the components in the illustration to the right.
Only carry out the steps described in the different sections if you have completely understood the proce-
dure and know exactly what to observe.

a) Gluing on the Wing Halves

Before gluing the wing halves (1) to the wing connector (2)
from above, remove the double-sided adhesive tape pro-
tection foil at the glue point.
When gluing on the wings, ensure that the wing connector
is placed precisely in its hollow (3).

b) Gluing the Wings to the Fuselage

Before gluing the wing (1) to the fuselage (2), remove the
double-sided adhesive tape protection foil at the glue point.
When gluing on the wings, ensure that they are put on the
fuselage centrally and at a right angle. The two distances A
and B must be of equal length.
Then glue on the wing cover from below with a piece of
adhesive tape.
Only now attach the two large labels (3) to the wings. They
additionally reinforce the wing adhesion.
18
Figure 2
Figure 3