Advertisement
INSTALLING THE MOUNTING ACCESSORY
A]ach the wall mount bracket to the structure using suitable tapping screws (PLASTIC ANCHOR, P
INSTALLING THE MOUNTING ACCESSORY
illustrated in the figure. The wall bracket must be a]ached to a structure such as hardwood, wall s
Attach the wall mount bracket to the structure using suitable tapping screws (PLASTIC ANCHOR, PTS1 M8x40L)
a suitable material capable of supporang the final mount assembly. The installer may need to cha
as illustrated in the figure. The wall bracket must be attached to a structure such as hardwood, wall stud, concrete
of mounang or hardware used depending on the wall material.
or a suitable material capable of supporting the final mount assembly. The installer may need to change the
method of mounting or hardware used depending on the wall material.
LED ILLUMINATOR INSTALLATION WITH TRIPLE WALL MOUNT BRACKET
LED ILLUMINATOR INSTALLATION WITH SINGLE WALL MOUNT BRACKET
1
1
Use the bracket as a template to mark and drill the necessary holes in the wall
Use the bracket as a template to mark and drill the necessary holes in the wall. *NOTE: wall anchors are for
illustration only, and are not included.
3
With the bracket secured to the wall attach the illuminators with the supplied M6 nuts and bolts. For each
With the bracket secured to the wall a]ach the illuminators with the s
illuminator attach the center bolt first then rotate the illuminators to the required horizontal position, then secure
with the remaining nut and bold in one of the outer holes.
illuminator a]ach the center bolt first then rotate the illuminators to the re
Vertical adjustment can be made via the two hex bolts on each side of the illuminator.
with the remaining nut and bold in one of the outer holes.
Veracal adjustment can be made via the two hex bolts on each side of the il
A waterproof juncaon box is a]ached to the bracket rear plate. This allow
NOTE:
Recommended fasteners (not included):
• Head size: minimum 0.6"
the juncaon box and then split to each illuminator. This can be removed if n
• Screw or bolt diameter: maximum 0.5"
Tel: +1 (866) 446-3595 / (813) 888-9555
• Fastener strength: minimum 10 lb.
watchdog.com
Technical support Hours: 9:00AM – 8.00PM EST, Monday thru Friday
Rev Date: 04/20
INSTALLING THE MOUNTING ACCESSORY
A]ach the wall mount bracket to the structure using suitable tapping screw
illustrated in the figure. The wall bracket must be a]ached to a structure suc
a suitable material capable of supporang the final mount assembly. The inst
of mounang or hardware used depending on the wall material.
LED ILLUMINATOR INSTALLATION WITH TRIPLE WALL MOUNT BR
1
Use the bracket as a template to mark and drill the necess
3
4
3
Tel: +1 (866) 446-3595 / (813) 888-9555
watchdog.com
Technical support Hours: 9:00AM – 8.00PM EST, Monday thru Friday
2
2
Quick Start Guide
2
4
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
2
4
Advertisement
