HIKVISION H0T Series User Manual page 6

2). Loosen the trim ring to adjust the pan position
[0° to 360°].
3). Loosen the R adjusting screw to adjust the
rotation position [0° to 360°].
6. Tighten screws and the trim ring to finish the
installation.
2.1.2 Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box in advance.
Steps:
1. Paste the drill template on the ceiling/wall.
2. Drill screw holes and the cable hole on the ceiling
according to the drill template.
Figure 2-3 Drill Template of Junction Box
3. Take apart the junction box, and align the screw
holes of the camera with those on the Junction
box's cover.
4. Attach the camera on the junction box's cover with
supplied screws.
Figure 2-4 Attach the Camera on the Junction Box's
5. Secure the junction box's body on the ceiling/wall
with supplied screws.
Figure 2-5 Secure the Junction Box on the Wall/Ceiling
6. Route the cables through the bottom cable hole, or
the side cable hole of the junction box.
7. Combine the junction box cover with its body.
Cover
Junction Box
Body