Û Finish In; Additional Programme; Settings; Speed/Eco - Siemens WS K Series Instruction Manual And Installation Instructions

Additional programme settings
en
û Finish in
(û Finish in)
Before starting the program, you can
preselect the program end ("Ready in"
time) in hourly increments (h = hour) up
to a maximum of 24 hours.
To do this:
Select a program.
1.
The program duration is displayed
for the selected program, e.g. 2:30
(hours:minutes).
Press the û Finish in button
2.
repeatedly until the required number
of hours is displayed.
Press the ‹ button.
3.
The door will be locked.
The selected number of hours (e.g.
8 h) is shown in the display panel
and counts down until the wash
program starts. The duration of the
program is then displayed.
During the timer count-down, you can
change the preselected number of
hours as follows:
Press the ‹ button.
1.
Use the û Finish in button to
2.
change the number of hours.
Press the ‹ button.
3.
During the timer count-down, you can
add or remove laundry as required:
Press the ‹ button.
1.
Open the door and add or remove
2.
laundry.
Close the door.
3.
Press the ‹ button.
4.
The length of the program is
Note:
automatically adjusted when the
program is running.
Certain factors can affect the program
length, e.g.:
Program settings,
■
Detergent dosage (additional rinse
■
cycles if required due to foaming),
Load size/type of textiles (longer
■
washing for higher load and for
textiles which absorb more water),
Imbalances (e. g. due to fitted
■
sheets) are offset with several start-
ups of spin cycles,
Fluctuations in power supply,
■
Water pressure (infeeding speed).
■
14
\

Additional programme

settings

You can find possible
Note:
A d d i t i o n a l p r o g r a m m e s e t t i n g s
programme additional settings in the
overview; these differ depending on the
model.

speed/eco

(( ¦)
Button with two possible settings for
adapting the selected program:
( speed
■
Washing in a shorter time while
achieving a washing result that is
consistent with, but uses more
energy than, the selected program,
without the speed/eco setting.
Do not exceed the maximum
Note:
load.
¦ eco
■
Energy-optimised washing by
reducing the temperature while
achieving a washing result that is
consistent with the selected
program, without the speed/eco
setting.
Press the button to do this. First of all,
you can select the ( speed setting. If
you press the button again, the ¦ eco
setting is active. The respective symbol
is shown in the display when the setting
is activated.
If you press the button again, no setting
is active.

Rinse+

(Ô Rinse+)
Increased water level and additional
rinse cycle, extended washing time. For
areas with very soft water or for further
enhancing the spin result.

Less iron

(S Less iron)
Special spin sequence with subsequent
fluffing. Gentle final spin – residual
moisture in the laundry slightly
increased.