Table of Contents
Advertisement
Take the hoses out of the holders.
1.
Unscrew and remove all four
2.
transport brace screws.
Remove the sleeves. To do this,
remove the mains cable from the
holders.
Fit the covers. Lock the covers firmly
3.
in place by applying pressure to the
snap-in hooks.
Hose and cable lengths
Left-hand connection
■
Positioning and connecting
Right-hand connection
■
*depending on the model
The following are available from
Tip:
specialist dealers/the after-sales
service:
An extension for Aqua-Stop or cold
■
water supply hose (approx. 2.50 m);
order no. WMZ2380, WZ10130,
CZ11350, Z7070X0
A longer supply hose (approx.
■
2.20 m) for standard model
Water inlet
:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Observe the following when connecting
the machine:
Notes
Only operate the washing machine
■
using cold mains water.
Do not connect the machine to the
■
mixer tap of an unpressurised hot-
water boiler.
Do not use a used supply hose. Only
■
use the supply hose supplied with
the machine or one that was
purchased from an authorised
retailer.
Do not bend, squash, modify or cut
■
through the water supply hose
(otherwise its strength is no longer
guaranteed).
Only tighten the screw connections
■
by hand. If the screw connections are
tightened too much with a tool
(pliers), the thread may be damaged.
en
29
Advertisement
Table of Contents
