Table of Contents
Advertisement
0
Programme default
settings
T he default programme settings are
P r o g r a m m e d e f a u l t s e t t i n g s
displayed in the display panel after
selecting the programme.
You can change the default settings.
An overview of all programme settings,
which can be selected depending on
the programme, can be found from
~ Page 15.
Temperature
(Temp. °C)
Depending on what stage the
programme is in, you can change the
set temperature before and during the
programme.
The maximum temperature that can be
set depends on the programme that has
been selected.
Spin speed
(Spin 0)
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme.
Setting 0: The rinsing water is drained
but there is no final spin. The laundry
stays wet inside the drum, e.g. for items
that should not be spun.
Setting $: Rinse Stop = no final spin.
The laundry stays in the water after the
final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
To continue/end the programme
~ Page 26
Programme default settings
The maximum speed that can be set
depends on the model and programme
that has been selected.
Finish in 5
Before starting the programme, you
can preselect the programme end
("Ready in" time) in hourly increments (h
= hour) up to a maximum of 24 hours.
To do this:
Select a programme.
1.
The programme duration is
displayed for the selected
programme, e.g. 2:30
(hours:minutes).
Press the Finish in 5 button
2.
repeatedly until the required number
of hours is displayed.
The setting values are
Note:
increased using the Finish in 5 +
button, and decreased using the
Finish in 5 - button.
Press the Ü button.
3.
The programme starts.
The selected number of hours
(e.g. 8 h) is shown in the display
panel and counts down until the
wash programme starts. The
duration of the programme is then
displayed.
The length of the programme is
Note:
automatically adjusted when the
programme is running. Changes to the
default programme settings or
programme settings may also change
the programme duration.
After starting the programme (if a
Finish in 5 time has been selected and
the wash programme has not yet
started), you can change the
preselected number of hours as follows:
Press the Ü button.
1.
Use the Finish in 5 - or + button to
2.
change the number of hours.
Press the Ü button.
3.
en
21
Advertisement
Table of Contents
