Table of Contents
Advertisement
Programme default settings
en
The maximum speed that can be set
depends on the model and programme
that has been selected.
Finish in
Before starting the programme, you
can preselect the programme end
("Ready in" time) in hourly increments
(h = hour) up to a maximum of 24
hours.
To do this:
Select a programme.
1.
The programme duration is
displayed for the selected
programme, e.g. 2:30
(hours:minutes).
Press the Finish in button
2.
repeatedly until the required number
of hours is displayed.
The setting values are
Note:
increased using the Finish in +
button, and decreased using the
Finish in - button.
Press the Ü button.
3.
The programme starts.
The selected number of hours
(e.g. 8 h) is shown in the display
panel and counts down until the
wash programme starts. The
duration of the programme is then
displayed.
The length of the programme is
Note:
automatically adjusted when the
programme is running. Changes to the
default programme settings or
programme settings may also change
the programme duration.
After starting the programme (if a
Finish in time has been selected and
the wash programme has not yet
started), you can change the
preselected number of hours as follows:
Press the Ü button.
1.
Use the Finish in - or + button to
2.
change the number of hours.
Press the Ü button.
3.
36
After starting the programme, you can
add or remove laundry if necessary.
~ Page 41
Advertisement
Table of Contents
