Table of Contents
Advertisement
This function allows the operator to permanently turn off the display of
certain parameters in the Engine Data and Vehicle Data menus. The
function is not available through any of the normal menus.
To run the function press and hold the upper Expand key while turning on
the vehicle ignition. The screen below will be displayed:
Press to
return to
HOLD TO
EXPAND
normal
operation
Press to
turn
HOLD TO
EXPAND
parameter
on/off
A 'y' to the left of the parameter name indicates the parameter will be
displayed. Otherwise, an 'n' indicates the parameter will not be displayed.
Press the lower Expand key to toggle between 'y' and 'n'. Press the upper
Set key to scroll the display up through the list and the lower Set key to
scroll down. When finished with this function, press the upper Expand key
to return to the normal Driver Information Center
parameters will be stored in permanent memory.
The following parameters can be turned on or off:
Engine Exhaust Temperature
BrakeSaver Application Pressure
BrakeSaver Temperature
Fuel Level
Reservoir "A" Pressure
Reservoir "B" Pressure
Tractor Application Pressure
Trailer Application Pressure
Trailer Emergency Pressure
Suspension 1 Pressure
Suspension 2 Pressure
Transmission Temperature
Auxiliary Transmission Temperature
Forward, Rear Axle Temperature
Center, Rear Axle Temperature
Rear, Rear Axle Temperature
Air Filter Restriction Pressure
Ammeter
Outside Temperature
PARAMETER ON/OFF
HOLD TO SET
HOLD TO SET
functions. The state of the
Lift Axle 1 Pressure
Lift Axle 2 Pressure
Lift Axle 3 Pressure
Lift Axle 4 Pressure
Air Start Pressure
Load Air Pressure
Press to
scroll the
parameter
list up
Press to
scroll the
parameter
list down
33
Advertisement
Table of Contents
