Huawei PowerCube 500 Manual page 13

Main Menu Second-Level Menu
Date and Time
Setting
Wizard
Network Parameters
Power System
Comm. Parameters
Battery
Parameters
Settings
When the battery type is TCB-
C/FCB-B, this parameter is
displayed.
ESS
When the battery type is ESU-
A/ESM-A, this parameter is
displayed.
12.4
Powering-On the Video Surveillance Equipment
Switch the M48300N1 circuit breaker to ON.
13
(Optional) Installing an ICC on a Pole
1. Secure the upper fastener to the
pole mounting kit.
Pole
mounting kit
4. Install the bracket onto the pole.
Third-Level Fourth-
Menu Level Menu
Time Zone -
Date and Time -
IP Address -
Subnet Mask -
Default
-
Gateway
Basic Battery
Parameters Type
NetEco
Primary IP
Network NetEco
Parameters Backup IP
NetEco Port
Number
Basic Rated
Parameters Capacity
Other Installation
Parameters Time
Charge Current
Parameters Limit
2. Install the upper pole mounting kit
to the pole.
Upper
fastener
5. Hoist the ICC.
Default
Value
UTC +08:00
Set this parameter to the local time zone.
Beijing
- Set this parameter to the local date and time.
192.168.0.10 Set this parameter based on the IP address
assigned by the network administrator.
255.255.255. Set this parameter based on the subnet mask
0 assigned by the network administrator.
Set this parameter based on the gateway address
192.168.0.1
assigned by the network administrator.
Normal Lead
Set the parameter based on the actual battery type.
Acid
192.168.0.10 Set an IP address for the active NetEco server.
192.168.0.10 Set an IP address for the standby NetEco server.
Please contact Huawei technical support if you
31220
need change the port number.
Set the parameter based on the actual battery
100 Ah
capacity.
- Set this parameter to the current time.
0.40 C10 0.05C10–1.00C10
3. Install the lower pole mounting kit to
the support.
6. Secure the ICC.
13
Setting