Hard-Drive Assembly; Removing The 2.5 In. Hard-Drive Assembly - Dell OptiPlex 7080 Small Form Factor Service Manual

Steps
1. Align the tabs from the right portion of the front bezel with the slots on the system chassis.
2. Move the bezel towards the system until the three tabs from the left portion of the bezel snap onto the chassis securing the bezel in
place.
Next steps
1. Install the side cover.
2. Follow the procedure in

Hard-drive assembly

Removing the 2.5 in. hard-drive assembly

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
About this task
The following images indicate the location of the 2.5 in. hard-drive assembly and provide a visual representation of the removal procedure.
after working inside your computer.
before working inside your computer.
Field service information 23