Control Kit Outdoor Box Installation - LG PRCKD21E Installation Manual

CONTROL KIT INSTALLATION
18
CONTROL KIT outdoor box
installation
Outdoor box installation location verification /
Punching holes
- Verify CONTROL KIT outdoor box installation
location in AHU product and punch the holes.
- Verify the location of the holes at the back of
Outdoor box and if there are installation ma-
terial
4 holes
<Outdoor box backside>
Product name Specification Quantity(EA)
Washer M10, SUS
Bolt M10X 70, SUS
Nut M10, SUS
Washer M10, SUS
Outdoor box / CONTROL KIT installation
- Match the holes punched on the side of AHU
and the holes of outdoor box and fix them
with bolts and nuts (CONTROL KIT enclosed)
and washer(outdoor box enclosed).
Nut (4EA)
Washer
(4EA)
4-Ø12 hole
Location
4 Outdoor box enclosed
4
Control Kit
4
enclosed
4
Washer (4EA)
Bolt (4EA)
- Fix CONTROL KOT inside the installed out-
door box. During the fixing, separate the nut
locked to the bolts inside outdoor box and fix
as follows.
Control Kit
Reduce the bracket
gap and fix by
tightening
the nuts.
- After completing the installation, verify if it is
composed as follows.
! CAUTION
• Do not install the product by one per-
son. It may cause injury.
• After installation of the product, check if
the bots and nuts are properly fixed.
• After installation of the product, adjust the
wire fixing bracket gap at the bottom of
outdoor box to block the wire penetration
space. (Rats, animal, etc. may enter and
damage the electric wires.)
• After installation of the product, verify
the sealed status of AHU and outdoor
box connection part. If there is a defect
in the seal, it may cause leakage.
• If AHU is installed outside, to protect
CONTROL KIT, make sure to install out-
door box.
Washer
(4EA)
Nut (4EA)