Miele KM 7404 FX Operating And Installation Instructions page 26

Before using for the first time
Setting up Miele@home
Connecting via the app
The Miele@mobile app can be used to
connect to your network.
 Install the Miele@mobile app on your
mobile device.
To log in you will need:
1. Your WiFi network password.
2. The password of your hob.
The password for your hob consists of
the last nine digits of the serial number.
This can be found on the appliance's
data plate.
 Switch the hob on.
 Start the Miele@mobile app.
 Touch the 0 and 5 sensors at the
same time for 6 seconds.
The seconds can be seen counting
down in the timer display. After the 6
seconds have elapsed, the : code is
displayed in the timer display for 10
seconds.
You now have 10 minutes to configure
the WiFi.
 Follow the instructions in the app.
26
Connecting via WPS
Pre-requisite: You must have a WPS
(WiFi protected setup) compatible
router.
 Switch the hob on.
 Touch the 0 and 6 sensors at the
same time for 6 seconds.
The seconds can be seen counting
down in the timer display. After the 6
seconds have elapsed, a progress light
appears during the connection attempt
(for max. 120 seconds).
The WPS log in is only active during
these 120 seconds.
 Activate the WPS function on your
router.
If the connection was successful, the
code : appears in the timer display.
If the connection could not be
established, the timer display will show
the code :. You have probably not
activated WPS at your router quickly
enough. Repeat the steps above.
Tip: If your WiFi router does not support
WPS, please connect via the
Miele@mobile app.