1. Overview 1.1 Introduction The No-Cascading new CAN Fiber Optic Converter is a multi-master and high performance Field bus Control System (FCS). The modular fiber optic transmission system can be used to transmit CAN-based bus systems such as DeviceNet or CANOpen via fiber optics data interfaces over a pair of multi mode or single mode optical fibers.
1.3 Warranty n Repair Please contact your local distributors when product is defective. Please apply ¨ RA in advance and prepay shipping cost when returning the defective product to us. We will pay the cost for sending it back to you. Please attach a statement clearly describing the problem.
2 Installation 2.1 Package Contents · Fiber Optic Converter · CD Please contact dealer or distributor if part is missing or damaged. Enclosure Panel 1: LED Rotary button Console Power LED: LED No LED For LED Name LED Function CAN0 Transmitting Receiving Error...
Page 6
Others: Name Relevant Function Remarks Baudrate CAN0 Rotary button Configure baud rate by button,fast configuration RS232 CAN0 Console port Configure baud rate by software on computer V+ Power input DC 9~40V, With SPD,RCP,OCP V- Power input DC 9~40V,With SPD,RCP,OCP Panel 2: Fiber optic CAN DIP Switch Function...
2.3 Install Methods 1. Switch off all power supply before installation. 2. Connect the local “TX” Fiber Optic to the remote “RX” Fiber Optic, the local “RX” to the remote “TX”. And ensure that fiber is properly aligned to the receiving connector. 3.
2.4 Configure the baud rate by software Switch the “B0” button to F position and connect the straight line(NOT cross line) to the console port(DB9) and the other end of the line to the computer. 1.Open CANConfig and click“CAN FIB-100BT”,you will see 3 options: Basic Info,Baud rate and Filter.
Page 10
3.3 Filter The CAN FIB-100BT has a strong message filter,on“Filter” option button,The user can set up the filter.This function depends on the work condition of the user. How to use the filter function: (1) Select “Filter Enable”and you can revise the content of the filter. (2) Select the channel that needs filter function from the sub list of“Port”.