Table of Contents
Advertisement
Drive bay configurations and requirements
This topic describes the drive bay configurations supported by the server and the requirements for hardware
configurations.
Depending on models, the server supports:
• Up to twenty-four 2.5-inch or twelve 3.5-inch SAS/SATA/NVMe front drives
• Up to eight 2.5-inch SAS/SATA/NVMe or four 3.5-inch SAS/SATA/NVMe middle drives
• Up to eight 2.5-inch SAS/SATA or two 7mm SAS/SATA rear drives
• Up to two M.2 SATA/NVMe drives
For a list of supported drives, see:
https://static.lenovo.com/us/en/serverproven/index.shtml
Drive bay combinations
The following table shows the supported drive bay combinations for the chassis with 3.5-inch/2.5-inch front
drive bays.
• "Supported drive bay combinations (Two processors installed)" on page 144
• "Supported drive bay combinations (One processor installed)" on page 146
.
Chapter 4
Server hardware setup
143
Advertisement
Table of Contents
