Advertisement
KB200 REPLACEMENT SHOCK INSTRUCTIONS
Materials Supplied:
Shock
Key
1. Unlock the liner dispenser with the key (included) and remove
the four screws securing the liner dispenser to the frame. Remove
plastic liner dispenser from wall.
2. There should be six screws holding the metal mounting frame to
the wall. Remove the four lower mounting screws. Keep all of these
screws to remount the unit.
3. Loosen the upper two mounting screws, but do not remove them.
You should be able to lift the unit off the upper mounting screws
using the keyhole slots.
4. Once the unit is removed from the wall, allow the unit to close
and lay it flat on a non-abrasive table or countertop with the frame
side facing up.
5. Using a flat head screwdriver, release the "C" clip (which holds
the bottom of the shock to the ball stud) by sliding the screwdriver
between the "C" clip and the head of the shock. Once released pull
the head of the shock off the ball stud. Repeat this for the other end
of the shock.
6. Take the new shock and attach the thin end to the ball stud
closest to the bed of the unit by pushing it until you hear it click into
place. Twist the head back and forth to ensure it is secure.
7. Take the other end of the shock in one hand and the wall portion
of the frame in the other. Slightly pull up on the frame until the head
of the shock lines up with the ball stud. Push the shock onto the
ball stud until it clicks into place. Twist the head back and forth to
ensure it is secure.
8. Remount the unit using the keyhole slots and the screws that
were left in the wall. Replace the four lower mounting screws that
were removed. Tighten all six screws to ensure the unit is secured
to the wall.
9. Reattach the liner dispenser to the frame using the four screws
you removed earlier. Close and lock the liner dispenser with the key
(included).
10. Open and close the unit several times to ensure the shock is
working correctly. Clean the unit and work area.
Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112
Materials Needed:
Flat Head Screwdriver
®
Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: 303.539.8399
www.koalabear.com
P/N 472-KIT
Screwdriver
Ball Stud
Thin End of
Shock
Ball Stud
Slightly lift
frame
until ball stud and
shock head line up.
Ball Stud
P/N 307 December 2010
"C" Clip
Frame
Advertisement
