Installing The Ink Tanks - Canon imagePROGRAF TM-305 Setup Manual

Hide thumbs Also See for imagePROGRAF TM-305:
Table of Contents

Advertisement

Installing the Ink Tanks

Install the 5 ink tanks by following the instructions on the screen.
1
Instructions on ink tank installation are
shown on the touch screen. Open the ink
tank covers as instructed by grasping the
handles.
4
Open the pouch and remove the ink tank.
B
• Never touch the ink holes
(A) or metal contacts (B).
Important
Touching these parts may
cause stains, damage the
ink tank, and affect print
quality.
• Avoid dropping the ink
tank after removing it from
the pouch. Otherwise,
ink may leak and cause
stains.
• Do not remove ink tanks to
shake them after they have been
mounted. Doing so may cause ink
to spill.
7
Repeat steps 2 to 6 to install each of the
ink tanks.
2
While pushing the tip of the ink tank lock
lever horizontally, open the ink tank lock
lever upwards.
5
Insert the ink tank into the holder, with the
ink holes facing downwards as shown in
A
the figure.
Important
8
Close the ink tank covers.
• If the ink tank does not fit into the
holder, check that the color on the
ink tank label matches the color
shown on the ink tank lock lever.
Check also the orientation of the ink
tank.
6
3
Shake each ink tank gently 1 or 2 times
before opening its pouch.
• Failure to shake the ink tanks
may result in reduced print quality
Important
because ink ingredients have
settled on the bottom of the tank.
• If the ink tank is cold, allow it to
adjust to room temperature before
Note
attaching it to the printer.
6
Close the ink tank lock lever until it clicks.
9
Check that the color of the ink tank that
was set is displayed on the touch screen,
and select OK.
• If the touch screen does not show
the color, repeat steps 2 and 6.
Important

Advertisement

Table of Contents
loading

Table of Contents