Huawei SVN2000 Series Quick Installation Manual page 5

Installing the Device into a Cabinet
Install the Device into the Cabinet Through L Guid
1 1
1 Fix the mounting ears to the chassis using M4 screws.
3
3 Place the device on the guide rails and push it into the cab
mounting bar of the cabinet. Fix the device to the cabinet u
Install the Device into the Cabinet Through Rear M
This method is applicable to any 19-inch standard cabinet.
If interface cards are to be installed in the front of the cabinet,
side, and screws for rear mounting ears at the power supply side;
front mounting ears should be installed at the power supply side,
1
3
1
1
At both sides of the rear of the cabinet, install
captive nuts in holes 1 and 3 for a 1U height. Fix
rear mounting ears to the cabinet using M6 screws.
3
de Rails
2 2
Bottom of the
guide rail
2
Install L guide rails and captive nuts. Align the lower
edges of the guide rails with the narrow edge of the
mounting bar of the cabinet. Install captive nuts into
holes 1 and 2 in the figure. The installation of the
guide rail on the left is identical with that on the right.
This method is applicable only to Huawei 19-inch standard
cabinet.
binet until the mounting ears touch the
using M6 screws.
Mounting Ears
front mounting ears should be installed at the interface card
; if the power supply is to be installed in the front of the cabinet,
and screws for rear mounting ears at the interface card side.
2 2
2
Install the screws for front and rear mounting ears
at both sides of the chassis.
3 3 Place the device into the cabinet with the screws at rear Pl th d i i t th
of the device touching the rear mounting ears. Push the
device until the front mounting ears touch the mounting
bar of the cabinet. Fix the front mounting ears of the
device to the cabinet using M6 screws.
5 5
2
1
bi t ith th t