Advertisement
You tan install the device at any desired place. Please make sure that the device is not exposed to extreme
heat, moisture or dust. There shouid not be any cables iying around. You endanger your own and the safety
of others!
Please consider that for safety reasons unauthorized modifications to the device are forbidden!
INSTALLATION OF THE LAMPS
(POLE BURNER R-7-S 23OV/lOOW)
To install the lamps
D
not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
O
was not designed for. Damages caused by non-observance are not subject to warranty.
Ciose the lid and make Sure that the venting Slots are not blocked.
D
not operate this device with opened Service iid!
O
INSTALLATION
When instaiiing the devlce, make sure there is no highly infiammabie material
When choosing the device' s installation place, please make sure that the venting Slots are not covered by
other devices or decoration material.
Mount the projector with the mounting bracket to your trussing System. For safety reasons use an additional
safety rope.
This device falls under protection ciass i. Therefore it is essential that the yellow/green conductor gets
connected to earth.The eiectric connection must be carried out by a quaiified employee.
OPERATION
After you connected the effect to the mains, the DS-10 Starts running. You tan do without a controller as the
DS-10 features a built-in microphone, which provides automatic Sound control.
in Order to obtain the best Ventilation possibie, keep the venting Slots clean from dust and dirt. We also
recommend frequent cieaning of the lenses and mirrors.
if the lamp burns out the fine-wire fuse of the DS-10 might fuse, too. Replace the fuse by a fuse of same type
and rating.
Should you need any spare Parts, please use genuine Parts oniy and give your dealer the serial numbers of
the Parts in question when orderfng.
Before repiacing the iamp, unpiug mains iead and let the iamp cool down.
When operating halogen lamps, the lamp will resch temperatures of up to 200°C.
Unplug from mains before!
5
open the Service iid. During the installation do not
Advertisement
