Table of Contents
Advertisement
Quick Links
Installation
Packing List
IS
T H
E
S ID
U P
215-1525 Rev. G; EN 07-209
© 2007 Bradley Corporation
Page 1 of 8
7/23/07
IMPORTANT!
Read this entire installation manual to ensure proper installation, then file
this manual with the owner or maintenance department. Compliance and
conformity to local codes and ordinances is the responsibility of the installer.
Pressurized plumbing fixtures must be installed in accordance with
manufacturer's recommendations. The supply piping to these devices must
be securely anchored to the building structure to prevent unnecessary
movement of the installed device when operated by the user. Use extreme
caution when installing the device to prevent damage to the exposed
significant surface.
Separate parts from packaging and make sure all parts are accounted for
before discarding any packaging material. If any parts are missing, do not
begin installation until you obtain the missing parts.
Flush water supply lines before making connections. DO NOT use pipe dope
on any faucet or supply connections. Possible solenoid contamination could
occur which will void any warranty. Teflon tape is the recommended sealant.
The incoming water supply can be tempered or cold. An optional Bradley
Vernatherm™ thermostatic mixing valve delivers tempered water at a
temperature no greater than 105°F. The 1100 series faucet operates at a
flowing water pressure of 20–80 PSI. A vandal-resistant .5 GPM flow restrictor
ensures a constant flow rate at all pressures.
Product warranties may be found under "Product Information" on our web
site at www.bradleycorp.com.
Installation
For Service Only
Aerada™ 1100 Series
Low Arc Faucet
S53-302 Battery Infrared
Metering Faucet (Center
Shank with 4" Trimplate)
P.O. Box 309, Menomonee Falls, WI USA 53052-0309
PHONE 1-800-BRADLEY FAX (262) 251-5817
http://www.bradleycorp.com
Advertisement
Table of Contents
Related Manuals for Bradley Aerada 1100 Series S53-302
Summary of Contents for Bradley Aerada 1100 Series S53-302
- Page 1 Possible solenoid contamination could occur which will void any warranty. Teflon tape is the recommended sealant. The incoming water supply can be tempered or cold. An optional Bradley Vernatherm™ thermostatic mixing valve delivers tempered water at a temperature no greater than 105°F.
- Page 2 ASSEMBLY (INCL. HEX NUTS, RUBBER WASHER & BRASS MTG. WASHER) SENSOR CABLE S39-601 269-1753 HOSE, BRAIDED SILICONE 269-1752 LUBRICANT 269-1776 ADAPTER (OPTIONAL) 153-436 OPERATION BOX FILTER 153-437 OPERATION BOX ASSEMBLY S08-366 7/23/07 Bradley Corporation • 215-1525 Rev. G; EN 07-209...
- Page 3 5. Position the brass mounting washer onto the stud from beneath the deck. The sensor cable should be free from contact with the brass mounting washer. Screw the hex nut onto the faucet stud and secure the faucet to the deck by tightening the nut. Bradley Corporation • 215-1525 Rev. G; EN 07-209 7/23/07...
- Page 4 NOTE: Refer to Figure 2 when making supply connections. 1. Connect one end of the braided hose (supplied by Bradley) to the end of the faucet stud. 2. Connect the other end of Bradley’s braided hose to the operation box’s 1/2" NPS inlet fitting.
- Page 5 7. FOR OPTIONAL PLUG-IN AC ADAPTER: Plug one end of the adapter into the adapter inlet located on the underside of the operation box and the other end into an electrical outlet. Bradley Corporation • 215-1525 Rev. G; EN 07-209 7/23/07...
- Page 6 Q: Will leaving the batteries in the operation box affect the performance of the faucet when using the 100-240 VAC adapter? A: Yes. In the case of a loss of power to the adapter, the faucet will default to battery power. 7/23/07 Bradley Corporation • 215-1525 Rev. G; EN 07-209...
- Page 7 Problem: Limited water flow Cause: Dirt and debris have built up in the valve or strainer. 1. Remove and clean strainer. If strainer needs to be replaced, order Bradley part no. 173-028. 2. Check the piston for smooth movement. To check the valve's piston for free and smooth movement, follow the procedures outlined below: 1.
- Page 8 Repair Kit S65-259 Item Description Nut 3/8-24 Hex Jam Thermostat O-Ring O-Ring O-Ring S45-2082 Checkstop and O-Ring Supply Hose Kit Stem CHECK STOPS Thermostat SUPPLY HOSES Piston Spring Strainer 173-028 Valve Body 7/23/07 Bradley Corporation • 215-1525 Rev. G; EN 07-209...
Need help?
Do you have a question about the Aerada 1100 Series S53-302 and is the answer not in the manual?
Questions and answers