Advertisement
5.5.
Assemble the base (fig.8.B) onto the legs (fig.8.C) using four nuts (fig.8.CC) and four bolts (fig.8.BB). (fig.8). Align drawer pin pivot
(fig.8.1) and centre support (fig.8.2).
5.6.
Insert drawer base (fig.9.O) into left hand drawer side (fig.9.M) (fig.9). Push firmly against a hard surface to snap drawer base into
drawer side.
NOTE:
Follow indicator on inside of drawer front for drawer direction and drawer side (R/L).
NOTE:
Ensure drawer side is fully engaged with the drawer base.
fig.8
5.7.
Insert the drawer base (fig10.O) into the right hand drawer side (fig.10.N). Push firmly against a hard surface so that the base fixes into
the drawer side (fig.10).
5.8.
Take previously assembled drawer and attach to drawer front (fig.11.M). Attach using screws (fig.11.EE) (fig.11).
NOTE:
Ensure all location clips are fully engaged from drawer sides to drawer front.
fig.10
5.9.
To install the drawers (fig.12, fig.13), extend the drawer slides (fig.12.1) and insert the brackets (fig.12.2) on each side of the drawer
into the slots on the slides ensuring correct alignment. Close the drawer to set slides in position.
5.10.
To remove drawers (fig.13), fully open empty drawer. Push down on the right release lever while pushing up the left release lever. Pull
drawer outward while holding both levers until drawer is released.
fig.12
© Jack Sealey Limited
Original Language Version
fig.9
fig.11
fig.13
AP47PWS
Issue 1
11/03/2020
Advertisement
