Sealey AP1372A Instructions

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
1. safety
warninG! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this bench.
‰
locate bench in a suitable working area.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
warninG! use bench on level and solid ground, preferably concrete. Avoid tarmacadam since the bench may sink into the surface.
‰
Keep the bench clean and tidy in accordance with good workshop practice.
9
Keep children and unauthorised persons away from the working area.
9
do not use the bench for any purpose other than that for which it is designed.
8
do not exceed maximum capacity of workbench.
8
do not undertake work on the bench without the work piece being adequately secured. use clamps or a vice (not included) to secure the
8
work piece. Available from your sealey dealer.
do not use the bench out of doors.
8
do not get the bench wet or use in damp or wet locations or areas where there is condensation.
8
do not clean the bench with any solvents which may damage the paint surface or the protective coating on the wooden top.
8
2. introduction
i
Heavy duty powder coated metal frame with a 40mm MDF work surface. Two configurations available with a combination of lockable drawers
and cupboards. Features adjustable feet to help stability when placing on an uneven surface. Supplied flat packed with two keys.
3. specification
model no: ................................................................ AP1372A
size (W x d x H):...................................1200 x 600 x 865mm
drawer (x2): ............................................415 x 160 x 415mm
capacity: ...................................................................... 300kg
4. contents
4.1. panels etc.
Part description
A top
B1 left side
B2 right side
c Bottom
d support
e drawer
f1 left door
f2 right door
g shelf
H Back
i leg leveller assy.
J1 left slide
J2 right slide
K rail
© Jack sealey limited
instructions for
workstation with 2 drawers & 2 cupboards
model no:
Quantity
1
1
1
1
1
2
1
1
2
2
4
2
2
2
Original Language Version
ap1372a
AP1372A | issue 1 07/04/16