Operation - Baier BSS 608H Manual

– After the wet vacuuming: Clean the flat
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All accessories with a nominal
width of 35 mm can be connected.

Operation

Rotating knob
Appliance OFF
Appliance ON
Automatic filter cleaning: OFF
Appliance ON
Automatic filter cleaning: maxi-
mum interval
Appliance ON
Automatic filter cleaning: mini-
mum interval
Turning on the Appliance
 Plug in the mains plug.
 Set the rotary switch to the desired pro-
gram.
Adjust the suction output
 Set the suction output (min - max) at the
rotary switch.
Working with electrical power tools
DANGER
Risk of injury and damage! The socket out-
let is only for the connection of power tools
to the vacuum cleaner. Any other use of the
socket outlet is not permitted.
 Connect the mains plug of the electric
power tool to the vacuum cleaner.
The vacuum cleaner is in standby
mode.
 Switch on the appliance at the rotating
knob.
22
Note: The vacuum cleaner is turned on and
off automatically with the electric power
tool.
Note: The vacuum cleaner starts automat-
ically within 0.5 seconds and continues to
run for 15 seconds after the power tool has
being switched off.
Note: Please refer to "Technical specifica-
tions" for the power connection specifica-
tions of the power tools.
Illustration
 Remove the elbow from the suction
hose.
 Attach the tool adapter to the suction
hose.
Illustration
 Connect the tool adapter to the electric
power tool.
Note: The different suction hose sections
are required to allow an adjustment to the
connection sections of the processing
tools.
 Set the minimum volume flow for the
suction hose cross section at the rotary
switch.
The scale displays the suction hose cross
section.
Note: To use the appliance as dedusting
device for the mobile operation (processing
tool connected to the vacuum cleaner) the
built-in monitoring must be adjusted to the
connected processing tool (dust-generat-
ing device). This means that the user must
be warned if the minimum volume flow of
20 m/s that is required for the suction is fall-
en short of.
Note: Please refer to the type plate for the
specification of the minimum volume flow in
dependence on the negative pressure.
Automatic filter cleaning
The device is equipped with a special filter
dedusting function, which is particularly ef-
fective against fine dust. The flat fold filters
are automatically cleaned every 15 sec-
onds (AUTO MAX) or every 60 seconds
(AUTO MIN) by a blast of air (pulsing
noise).
– 5
EN