J. Electric Supply; Installation Checklist - Victory V-Series Owner's Manual

SECTION 2-INSTALLATION
J. Electric Supply (continued)
freezer. It is most important that a voltage reading be
made at the compressor-motor electrical connections, or
as close to the compressor- motor as possible, while the
refrigerator or freezer is in operation, to assure that the
correct voltage required by the compressor is being
supplied.
All refrigerator or freezer electrical systems are internally
grounded.
K. Installation Checklist
After the cabinet has been installed, leveled and cleaned
as described in the preceding paragraphs, refer to the
following checklist prior to start-up.
● ● Full voltage of the correct type, on a line not
affected by the operation of other electrical
appliances, must be available for proper
operation. Condensing units are designed to
operate with a voltage fluctuation of plus or
minus 10% of the voltage indicated on the
cabinet electrical data plate.
condensing unit due to exceeding the high or low
voltage limits will void the factory warranty.
● ● Leak check all exposed refrigeration line
connections. Make sure refrigeration lines are
not dented, kinked or rubbing.
● ● Check condenser fan for freedom to rotate
without striking any stationary members.
● ● Cabinet must be properly leveled.
● ● Do Not become alarmed if a trace of freon gas is
detected in the internal cabinet air. This may be
due to refrigerant used in expanding the foam
insulation used in this cabinet.
NOTE: All motors are lifetime oiled and sealed. All self-
contained models are shipped from the factory
with the service valves opened ready for
operation.
When ordering replacement parts, you must
include the complete cabinet model and serial
numbers.
Burn-out of a
"End Of Section, Click Here For Table Of Contents"
SECTION 2-INSTALLATION