Advertisement
•
Once the distance adjustment has been carried out,
block again the stop stud (W) by using a blocking
stud (Z).
•
Finally, move the slide manually towards the fur-
thest position on the right, and block it by pressing
downwards. Activate the general machine switch
again. Take great care, as when this switch is activa-
ted again the machine will start up instantaneously
until the cutting cycle that had been started before
turning off the machine is completed.
4.4
Safety recommendations
1
Do not try to start up or handle the machine until all
security aspects, installation instructions, the operating
guide, and maintenance procedures have been conside-
red and understood.
Always cut off the power supply before carrying out any
2
cleaning or maintenance work.
3
Always keep the machine and its surroundings clean.
Always work with dry hands.
4
Protective goggles should be used even if the machine
5
has protection elements.
6
Make sure the machine has an earth connection.
In case of emergency, block this switch to stop the cutter
7
from turning.
See figure 14
13
13
Advertisement
