Special Operation; Setting The Fixed Airflow Direction - Mitsubishi Electric Mr.Slim MA Series Manual

WIRELESS REMOTE CONTROLLER

5 . Special Operation

F
9
A
5.1. Setting the fi xed airfl ow direction
Fig. 5-1
D-76
Some functions cannot be operated depending on the air conditioner.
Confi rm whether the air conditioner supports each function, and then op-
erate the air conditioner.
D
<Switching to the special operation mode>
1. Press the
• If the weekly timer is enabled, press the
the timer. (
2. Press the
• The Function setting screen will be displayed and the function No. A
will blink.
1
<Transmitting the settings>
• When you perform each operation,
blinks to indicate that the
settings. Point the transmission area of the wireless remote controller
4
towards the receiver on the indoor unit and press the
2
transmit the settings. Confi rm that the indoor unit beeps at this time.
<Exiting the special operation mode>
3
1. While the operation screen for each function is displayed, press the
5
• The Function setting screen will be displayed and the function No. A
will blink.
2. Press the
• The display returns to the normal screen.
1. In the Function setting screen, press the
No. "2".
2. Press the
C
B • The vane number B blinks. (Fig. 5-1)
3. Press the
• For information about the vane numbers, refer to the indoor unit
operation manual.
4. Press the
• The airfl ow direction setting C blinks. (Fig. 5-1)
5. Press the
to fi x the vane.
Step 1
No setting
6. Press the
Note:
Draft reduction
The airfl ow direction for this setting is more horizontal than the airfl ow
direction for the "Step 1" setting in order to reduce a drafty feeling. The
draft reduction can be set for only 1 vane. The setting is enabled only for
the last vane that was set.
button 1 to stop the air conditioner.
F disappears.)
button 2.
D on the remote controller display
button 3 must be pressed to transmit the
button 2 or the button 5.
button 2.
button 3.
button 4 to select the vane number.
button 3.
button 4 to select the airfl ow direction at which you want
Step 2 Step 3
Draft reduction
(No display)
button 3 to transmit the settings.
button 9 to disable
button 3 to
button 4 and select function
Step 4 Step 5