Mitsubishi Electric Mr.Slim MA Series Manual page 94

MA REMOTE CONTROLLER
[ 4 ]
Manual vane angle
Ref. address
Unit No.
Vane 4-way
Cur. Cursor
F1 F2 F3
Function settings
[ 5 ]
5 Manual vane angle
Select:
Outlet
Manual vane angle
Manual vane angle
Setting
Select: SELECT
Outlet
Manual vane angle
Setting
*Draft reduction
The [Draft reduction] mode keeps the vane angle more horizontal than the angle of
Step 1 so that the airflow will not be directed toward the people.
This function can be set only for one outlet.
This function cannot be set for models with two or three outlets.
In the Draft reduction mode, the airflow may cause the ceiling discoloration.
*Draft reduction
The [Draft reduction] mode keeps the vane angle more horizontal than the angle of Step 1 so that the airflow will not
be directed toward the people.
28
This function can be set only for one outlet.
This function cannot be set for models with two or three outlets.
In the Draft reduction mode, the airflow may cause the ceiling discoloration.
D-94
Select "Vane" with the F1 button.
Select "4-way" or "2-way" with the F2 or F3 button,and press the
/2-way
F4 button.
Angle
F4
The current vane setting will appear.
The current vane setting will appear.
Select the desired outlets from "1" ,"2" ,"3" ,"4" ,or "1,2,3,4 (all outlets)"
Select the desired outlets from "1," "2," "3," "4," or "1,
with the F1 or F2 button.
2, 3, 4 (all outlets)" with the
Angle
Press the F3 or F4 button to go through the following options and select
Press the F3 or
the desired setting.
options and select the desired setting.
<Vane setting>
No setting
Angle
No setting
Step 3
Draft
Step 3
reduction*
Press the
SELECT
Draft
reduction*
A screen will appear that indicates the setting
information is being transmitted.
The setting changes will be made to the selected
Press the SELECT button to save the settings.
outlet.
The screen will automatically return to the previous
screen when the transmission is completed.
A screen will appear that indicates the setting information is being transmitted.
Make the settings for other outlets, following the
The setting changes will be made to the selected outlet.
same procedures.
The screen will automatically return to the one shown above (step 4) when the
transmission is completed.
Make the settings for other outlets, following the same procedures.
If all outlets are selected,
the next time the unit goes into operation.
If all outlets are selected,
Navigating through the screens
goes into operation.
To return to the previous screen ......
Navigating through the screens
• To return to the previous screen ............... RETURN button
or button.
F1 F2
F4 button to go through the following
Step 1 Step 2
Step 1
Step 4 Step 5
All
Step 4
outlets
button to save the settings.
All outlets
will be displayed
will be displayed the next time the unit
RETURN button
Step 2
Step 5