Table of Contents
Advertisement
Available languages
Available languages
2. Layout and items supplied
2.1 Layout (Fig. 1-4)
1. Intake air fi lter
2. Pressure tank
3. Wheel
4. Foot
5. Quick-lock coupling (regulated compressed
air)
6. Pressure gauge (for reading the set pressure)
7. Pressure regulator
8. On/Off switch
9. Transport handle
10. Safety valve
11. Drainage screw for condensation water
12. Pressure gauge (for reading the vessel pres-
sure)
13. Quick-lock coupling (unregulated com-
pressed air)
14. Oil sealing plug
15. Oil drainage screw / Oil level window
16. Overload switch
17. Oil fi ller opening
18. Wheel cap
19. Screw (internal hexagon) for fi tting the handle
20. 4mm Hexagonal key
21. Screw
22. Washer
23. Nut for fi tting the foot
24. Axle screw
25. Spring washer
26. Nut for fi tting the axle
2.2 Items supplied
Please check that the article is complete as spe-
cifi ed in the scope of delivery. If parts are missing,
please contact our service center or the nearest
branch of the DIY store where you made your
purchase at the latest within 5 work days after
purchasing the article and upon presentation of
a valid bill of purchase. Also, refer to the warranty
table in the warranty provisions at the end of the
operating instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Anl_SA_TE_AC_400_100_10_V_SPK8.indb 18
Anl_SA_TE_AC_400_100_10_V_SPK8.indb 18
GB
Important!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Compressor
•
Intake air filter (2x)
•
Wheel (2x)
•
Foot (2x)
•
Transport handle
•
Oil sealing plug
•
Wheel cap (2x)
•
Screw (Hexagonal) for fitting the handle (4x)
•
4 mm Hexagonal key
•
Screw (2x)
•
Washer (6x)
•
Nut for fitting the foot (2x)
•
Spring washer (2x)
•
Nut for fitting the axle (2x)
•
Axle screw (2x)
•
Original operating instructions
3. Proper use
The compressor is designed for generating
compressed air for tools operated by compressed
air.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
See warranty card of your country.
Noise
The noise emission values were measured in ac-
cordance with EN ISO 3744.
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
- 18 -
20.11.2018 08:34:48
20.11.2018 08:34:48
Advertisement
Table of Contents
