Advertisement
paper is not cut, and make those side of knife close to upper knife by turn proper
screws.
Please turn it little by little, we recommend about 5 degrees a time.
After finishing, please fasten all #B-15, clamping bolts.
If you need further information, please contact us at any time.
E-mail :
taewoo@cutex.co.kr
At first, please lay down upper knife
a little, please refer to below image.
And then turn no. 5 screw to make
lower knife to close to upper knife.
And then make lower knife close to
upper knife by turning no. 1~4 screws.
After doing above steps, please test
with paper and check which side of
- 5 -
http://www.cutex.co.kr
Advertisement
