Mulching Operation; Installing The Discharge Deflector - Simplicity 7800893 Operator's Manual

1.25 in
3,18 cm
Figure 9: Cutting height settings (approximate)

Mulching Operation

For best mulching results, cut up to a maximum of 1/3
of grass length and recycle ONLY when grass is dry.
1. Make sure the discharge deflector and grass bag
are removed, and the mulching plug is installed.
2. Set the cutting height adjust lever in the highest
cutting position (Notch 9).
3. Proceed mowing slowly. Gradually lower the cut-
ting height to obtain the best combination of cut-
ting and mulching performance. Cutting too much
grass in one pass, or cutting wet heavy grass may
cause clumping or plugging of the mower deck.
Installing the Discharge
Deflector
WARNING
!
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Disconnect spark plug wire and secure away from spark
plug. Engine and components are HOT. Avoid serious
burns, allow sufficient time for all components to cool.
1. Raise the mulching cover (A, Figure 10).
2. Install the deflector (B) to the deck under the
mulching cover, making sure that:
• The tabs (C) hook under the pivot rod (D).
• The locking tab on the deck (A, Figure 11) goes
through the slot in the deflector (B).
3. Lower the mulching cover against the deflector.
en
4.00 in
10,16 cm
Figure 10: Installing the discharge deflector
!
Figure 11: Deflector locking tab
Operation
D
B
A
A
C
B
15