Operating Instructions; Glass Information; Louvre Removal; Window Frame Assembly Removal - Vermont Castings DVR33 Homeowner's Installation And Operating Manual

Glass Information

Use only glass approved by Vermont
Castings, Majestic Products on this
fireplace.
• The use of any non-approved replacement glass
will void all product warranties.
• Care must be taken to avoid breakage of the glass.
• Under no circumstances should this appliance be
operated without the front glass in place, or with the
glass in a damaged condition.
• Replacement glass (complete with gasket) is
available through your Vermont Castings, Majestic
Products dealer, and should only be installed by a
licensed qualified service person.

Louvre Removal

To remove the louvre assembly top, lift the panel up
and out from the fireplace (Fig. 38).
NOTE: The louvre assembly bottom is hinged at
the bottom edge and swings down.
2.
1.
Fig. 38 Remove louvre assembly top.

Window Frame Assembly Removal

1. Turn the fireplace OFF (including the pilot).
2. If the unit has been operating, allow time for the
components to cool.
3. Remove the louvre assembly top.
4. Open the louvre assembly bottom.
5. Release the two clamps along lower edge of the
frame by pulling down on clamp handles (Fig. 39).
10004920

Operating Instructions

Louvre Assembly Top
Window Frame Assembly
FP444
Vermont Castings, Majestic Products: DVR33
6. Tilt window frame assembly out slightly at the
bottom, lift the frame up and away from the
fireplace.
7. To replace window frame assembly, reverse this
procedure.
Window
Frame
Assembly
Fig. 39 Window frame assembly removal.

Glass Cleaning

It is necessary to periodically clean the glass panel.
During start-up, it is normal for condensation to form
on the inside of the panel. This condensation causes
lint, dust and other airborne particles to cling to the
surface of the glass.
Also, initial paint curing may deposit a slight film on the
glass. It is therefore recommended the glass panel be
cleaned two or three times with a non-ammonia-based
household cleaner and warm water within the first few
weeks of operation. We recommend using gas
fireplace glass cleaner.
After the initial cleaning process, clean the glass two or
three times during each operating season, depending
on the environment in the house.
Clean the glass after the first two weeks
of operation.
Do not clean glass when it is hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
Lower
Clamps
Window Frame
Assembly
Pull Clamp Hook
Push Clamp
Handle
FP1191
23