Internal Dip Switch Settings - RaceAmerica 6428E Manual

INTERNAL DIP SWITCH SETTINGS

All scoreboard models have two banks of eight
DIP switches (S1 and S2) located inside the unit
numbered from 1 to 8 and can be switched ON
or OFF. Access to these switches require partial
dissassembly of the front of the scoreboard and
therefore are preset at the factory.
The ON position is indicated on the switch
itself. Each switch function and setting are
discussed below. Cycle power OFF/ON after
making any changes.
DIP Switch Bank S1
Scoreboards ship from the factory with the most
likely DIP switch settings for the scoreboard
model and position.
Model 6610 and 6410 Dual Line scoreboards
Factory Settings:
Upper position
Switch S1
1
2
3
4
5
6
7 Rt Lane - OFF
8
Lower position:
Switch S1
1
2
3
4
5
6
7 Rt Lane - OFF
8
Position
OFF
OFF
ON
OFF
OFF
OFF
Lt Lane - ON
OFF
Position
OFF
OFF
OFF
OFF
OFF
OFF
Lt Lane - ON
OFF
RaceAmerica Wireless Drag Racing Scoreboards
This configuration will display Dial-In (lower)
before the race, Reaction Time (upper) after both
vehicles start, Speed or Dial-In (lower) and ET
(upper) after both lanes finish. Data will remain on
the scoreboard for 30 seconds or until it is cleared
or new data is received.
Model 6628 and 6428 Single Line scoreboards
Switch S1
1
2
3
4
5
6
7 Rt Lane - OFF
8
This configuration will display Dial-In before the
race, Reaction Time after both vehicles start, Speed
and ET toggling after both lanes finish. Data will
remain on the scoreboard for 30 seconds or until
it is cleared or new data is received determined by
DIP switch 1 setting.
DIP Switch Definitions
If other configurations are desired, refer to the
specific DIP switch functions; XLscore PRO
software users can use the scoreboard control
panel to remotely reconfigure the scoreboards.
Lane Selection
DIP S1 Switch number 7 determines which
lane's race results will be displayed:
Lane to Display
Left
Right
Position
OFF
OFF
OFF
OFF
OFF
ON
Lt Lane - ON
OFF
7
ON
OFF
7