Holzmann ZS640P User Manual page 26

12 ASSEMBLY
12.1 The move and the dimension of location
 Using pallet truck or forklift while moving the machine

The center of gravity is in the first half of the machine. Using assistant to support and sta-
ble the machine, to prevent the dangerous from fall in.
12.2 Unpacking
Remove the sander and all parts from the container, and check to ensure that all parts are pre-
sent as indicated. If any parts are damaged or missing, contact your distributor immediately.
Move the sander to the worksite with a forklift or lifting hook. Make sure that the equipment used
for transportation of the sander is of adequate capacity.
Mount the table elevation crank handle as shown in figure. Align the slots on the shaft and crank
handle, and use the pin supplied to fasten the crank handle to the shaft.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
u n it:mm
Válcová bruska / mini wide belt sander ZS640P/ZS970P
Crank Handle
Strana 26