Infinity 20 x 20 All Trac Frame Tent Setup Instructions page 8

11. Start at one corner and manually lift the frame so that the leg (7'8" black) can slide over the corner fitting.
Pin the leg to the fitting. ( When raising the tent, raise INTO the wind)
12. Proceed to work your way around the tent putting one leg in at a time until all legs are standing and pinned.
Put baseplate under legs and attach 1" ratchets fron the "O" rings at the ends of the valance to the baseplates.
Tighten loosely.
13. Now that the frame tent is erected, fasten the rest of tent top completely to the frame, using the straps on the
inside of the tent. Evenly tighten the ratchets straps on the corners. Make sure the rope through the valance
slides smoothly. Make sure that all of the straps are tight and that the tent top is sitting evenly over the frame.
Evenly tighten the ratchets straps on the corners. Make sure the rope through the valance slides smoothly.
14. Drive a stake about four feet out from each leg and tie off the rope or ratchet to each leg.
Your tent installation is now complete.
20 x 50 All Trac Frame Tent Instructions page 2 of 2