Advertisement
8. Join the Regular T fittings to the corner poles (10'6" green) by sliding the pole over the fitting. Line up the hole of
the pole with those of the fittings and place a pin.
9. The perimeter is ready for assembly. Connect the Regular T's to the corners and Fan T's using the spreaders
(9'4'' white). Slide the poles over the fittings, line up the holes, and pin the pole and fitting together. When all of the
spreaders have been secured in place, the frame will be complete.
10. Slide the keder on the tent through the keder pipe starting at the regular t going up through the Half Crown, then
come back down the other side. Then slide the middle tent top pieces through the middles. Repeat the step for the
other end tent top section.
11. Secure the tent top to the frame by fastening the straps on the inside of the tent at each corner location.
12. Start at one corner and manually lift the frame so that the leg (7'8" black) can slide over the corner fitting.
Pin the leg to the fitting. ( When raising the tent, raise INTO the wind)
13. Proceed to work your way around the tent putting one leg in at a time until all legs are standing and pinned.
Put baseplate under legs and attach 1" ratchets fron the "O" rings at the ends of the valance to the baseplates.
Tighten loosely.
14. Now that the frame tent is erected, fasten the rest of tent top completely to the frame, using the straps on the
inside of the tent. Evenly tighten the ratchets straps on the corners. Make sure the rope through the valance
slides smoothly. Make sure that all of the straps are tight and that the tent top is sitting evenly over the frame.
Evenly tighten the ratchets straps on the corners. Make sure the rope through the valance slides smoothly.
15. Drive a stake about four feet out from each leg and tie off the rope or ratchet to each leg.
Your tent installation is now complete.
40 x 100 All Trac Frame Tent Instructions page 2 of 2
Advertisement
