20 x 20 All Trac Frame Tent Set Up Instructions
9'4"
10' 10"
Keder Pipe
Corner
Pre-Site Inspection- Call your local utitlity companies prior to installation for any underground obstructions.
1. Layout the frame parts in the estimated location pertaining to the diagram. The spreader pipe is placed out to form
the perimeter, and the rafters are laid in the interior location.
2. Start with the 8 way crown. Lay the crown on a flat surface to determine the correct placement, when the crown is on
a flat surface the angles that are not touching the ground (every other one) will correlate with the 4 corners.
Attach the hip rafters (14'4" red) to the 8 way crown at the angles, that do not touch the ground, by sliding the pole in or
over the fitting and lining up the holes in the pole with those in the fitting. Place a pin in the first hole to secure the pole
in place. Repeat at all four corners.
3. Attach the poles (10'6" green) to two of the remaining angles of the 8 way crown using the same technique as in step 2.
Attach the two 10'10" Keder Pipe to the remaining opposite angles aligning up the 8 way crown with the keder slots.
4. Connect the corner fitting to the hip rafter by sliding the pole in or over the fitting. Line up the hole of the pole with
those of the fitting and place a pin.
5. Join the Regular T fitting to the rafters by sliding the pole over the fitting. Line up the hole of the pole with those of
the fitting and place a pin.
6. The perimeter is ready for assembly. Connect the Regular T to the corners using the spreaders (9'4" white). Slide
the poles over the fittings, line up the holes, and pin the pole and fitting together. When all of the spreaders have been
secured in place, the frame will be complete.
7. Slide the keder on the tent through the keder pipe starting at the regular t going up through the 8 way crown, then
come back down the other side. Repeat the step for the other end of the tent top.
8. Secure the tent top to the frame by fastening the straps on the inside of the tent at each corner location.
9. Start at one corner and manually lift the frame so that the leg (7'8" black) can slide over the corner fitting.
Pin the leg to the fitting. ( When raising the tent, raise INTO the wind)
10. Proceed to work your way around the tent putting one leg in at a time until all legs are standing and pinned.
Put baseplate under legs and attach 1" ratchets fron the "O" rings at the ends of the valance to the baseplates.
Tighten loosely.
All Seasons Tent Sales
QTY
4
2
10' 10"
2
8
10' 10"
Keder Pipe
8
8 Way Crown AT
Pipe
SIZE
COLOR
Style
14' 4"
Red
Hip Rafter
Green
Keder
10' 6"
Green
Rafter
9'4"
White
Spreader
7' 8"
Black
Legs
Regular T
Corner
20 x 20 All Trac Frame instructions page 1 of 2
Components
QTY
Style
1
8 - Way Crown AT
4
Regular Corners
4
Regular T's
8
Ratchets
8
Baseplates
8
Weights / Stakes
40
Tent Pins
Optional Items
1
Brace Package